250 w outdoor twt power amplifier for satellite communications 811 hansen way p.o. box 51625, palo alto, ca 94303 tel: +1 (650) 846-3803 fax: +1 (650) 424-1744 e-mail: marketing@satcom.cpii.com www.cpii.com/satcom plays in the rain rugged, compact and lightweight ampli? er designed for outdoor use. ef cient and cost effective mounting at the antenna improves performance through minimized cable losses and saves cost in system design. employs a high ef? ciency helix traveling wave tube, reducing operating costs. simple to operate user-friendly microprocessor-controlled logic with integrated rs422/485 computer interface. digital metering is standard. easy to maintain modular design and built-in fault diagnostic capability via remote monitor and control. the T02KO series 250 watt peak power twt ampli er? environmentally sealed compact design for outdoor operation global applications meets international safety standard en- 60215, electromagnetic compatibility 89/336/ eec and harmonic standard en-61000-3-2 to satisfy worldwide requirements. worldwide support backed by over three decades of satellite communications experience, and cpis worldwide 24-hour customer support network that includes ? fteen regional factory service centers. 250 w outdoor twt power amplifier ka-band ka-band
ka-band for more detailed information, please refer to the corresponding cpi technical description. note: speci cations may change without notice as a result of additional data or product re nement. please contact cpi before using this information for system design. mkt 98, issue 15 6/07 pdf options: ? 1 ru remote control panel ? internal switch control and drive ? redundant or power combined subsystems ? integral linearized solid state ipa (lipa) ? integral block upconverter (refer to T02KO b-series twta) ? ethernet interface electrical frequency output power average power (twt) cw power (flange) bandwidth gain at rated power at small signal rf level adjust range attenuator step size small signal gain slope small signal gain variation gain stability (at constant drive and temperature) vswr input output load phase noise am/pm conversion noise power density noise figure intermodulation group delay linear parabolic ripple primary power power consumption power factor environmental (operating) ambient temperature relative humidity altitude shock and vibration mechanical cooling rf input connection rf output connection rf output monitor dimensions (wxhxd) weight heat and acoustic heat dissipation acoustic note 1: please consult cpi representative to con? rm that desired bandwidth is available over desired frequency range. specifications T02KO series mounting hardware is provided with each ampli er. certificate number: 30515 user-speci ed frequency range within the 27.5 to 31.0 ghz band, as limited by bandwidth capability of ampli er 1 250 w (53.98 dbm) peak 120 w (50.8 dbm) or 175 w (52.4 dbm) 100 w (50.0 dbm) or 145 w (51.6 dbm) 1000 - 2500 mhz, depending on desired frequency range 1 70 db min. 75 db min. (ssipa can be removed as an option. ssg without ssipa is 50 db min.) 0 to 25 db 0.1 db ?.04 db/mhz max. 1.0 db pk-pk max. across any 40 mhz segment; 2.5 db pk-pk max. across passband ?0.25 db/24 hours max. (after 30 minute warm-up) ?.0 db over temperature range 1.3:1 1.3:1 1.5:1 max. full spec. compliance; 2.0:1 max. continuous; any value for operation without damage 12 db below iess 308 continuous mask 2.5? /db max. for a single carrier up to 6 db obo(1.0?/db max. up to 3 db obo with optional linearizer) <-150 dbw/4 khz, below 21.2 ghz <-70 dbw/4 khz, transmit band (<-65 dbw/4 khz, transmit band with linearizer) 10 db max. (12 db max. with linearizer) -23 dbc or better with 2 equal carriers at total power level 50 w or 72.5 w cw (100 w or 140 w with linearizer) in any 40 mhz band 0.01 nsec/mhz max. 0.001 nsec/mhz sq. max. 0.5 nsec pk-pk max. 100-240 vac ?0%, single phase, 47-63 hz 800 va max., 650 va typ. 0.95 min. -40? to +60? c, with extra margin for solar loading 100% condensing 10,000 ft with standard adiabatic derating of 2? c/1000 ft 20 g pk, 11 msec, 1/2 sine / 2.1 g rms , 5 to 500 hz forced air with integral blower wr-28f wr-34g (wr-28g optional) 2.9 mm sma female 10.25 x 9.5 x 20 inches (261 x 242 x 508 mm) 52 lbs. (23.6 kg) max. 500 w max. 65 dba typ. (as measured at 3 feet from unit) keeping you on the air not up in the air
|
